I use a sonic cleaner and it gets them quite clean but not polished. I will probably try some of the other methods mentioned. At some point I would like to try the SS pin tumbler as it seems like it does a really good job of cleaning everything inside and out and leaves the brass looking like new. I did read that for the best accuracy you need to chamfer and debur after tumbling as the cases banging into each other put micro-dings in the case mouths.
So if you were going to reload for accuracy, what order of operations would you use? Clean, FL size, polish, chamfer/debur, reload and after that just neck size and hand polish the brass until it needs to be FL sized again?
|