|
Doubleought, I'd try Gun Parts first but you can make a follower. Especially for shotgun mags as the follower won't have the hump. I would measure the outside dimensions in the center of the body and measure the wall thickness from the bottom or one of the ends, wherever you can get to it easiest. Subtract that thicness from your length and width measurements and that will five you the basic rectangle. Any sheet metal 1/16" thick or a little thicker would work. Once you get the basic rectangle you may have to do a little more fitting as you go but it isn't that hard. You can probably use a Mauser or like magazine spring in it. Probably take a couple of hours but might be the way to get it shooting again. George
|