The Firing Line Forums - View Single Post

iraiam · December 13, 2012, 01:34 PM

I'm want to cut scope scallops into the barrel rib on my Ruger Redhawk, and make it into a "Hunter" Model.

Any smithies around that have done this?

I could not find any prints or drawings around, so I went ahead and oredered the Ruger rings and will take detailed measurements off of them. I have looked at a couple Hunter models at the LGS, the machining required is not complex.

December 13, 2012, 01:34 PM	#1
iraiam Senior Member Join Date: September 6, 2012 Location: Lakewood, CO Posts: 1,057	Ruger Redhawk Scope Scallops (cutting) I'm want to cut scope scallops into the barrel rib on my Ruger Redhawk, and make it into a "Hunter" Model. Any smithies around that have done this? I could not find any prints or drawings around, so I went ahead and oredered the Ruger rings and will take detailed measurements off of them. I have looked at a couple Hunter models at the LGS, the machining required is not complex. __________________ NRA Lifetime Member Since 1999 "I ask, sir, what is the militia? It is the whole people except for a few public officials." George Mason