The Firing Line Forums - View Single Post

nottelybill · February 27, 2011, 03:15 PM

If I asked this before I apologize before hand. I need to know screw size of the gas block screw on my Ruder 44 carbine. I discovered when I went to reset adj that someone had cross threaded mine in the pass. I think TPI is 40.

February 27, 2011, 03:15 PM	#1
nottelybill Member Join Date: October 9, 2006 Posts: 78	size of gas block screw ??? If I asked this before I apologize before hand. I need to know screw size of the gas block screw on my Ruder 44 carbine. I discovered when I went to reset adj that someone had cross threaded mine in the pass. I think TPI is 40.