Thread: 1903A4 trouble
View Single Post
Old June 25, 2012, 01:16 PM   #3
James K
Member In Memoriam
 
Join Date: March 17, 1999
Posts: 24,383
It can be done on the front receiver ring, but you have to control the heat very carefully and/or use heliarc or MIG/TIG to keep the heat area small. On the rear ring, the heat is not so critical, but it is still best to minimize the heated area. Use a soft steel rod so drilling and tapping will be no problem.

Jim
James K is offline  
 
Page generated in 0.03126 seconds with 8 queries