with all these measurements posted, here's one that raises a flag:
mehavey's ID's case ID after expander: 0.349/0.350"
mine are around .356... thats a rather hefty jump
Though my expander seemed to measure similarly to his. Is it possible I have mine adjusted wrong? Like I said, no flare can be felt or seen at the very edge, but how exactly SHOULD I go about adjusting it correctly?
though, my ID before expanding is bigger than his ID after... what could that indicate? cases not springy enough? resizing die not resizing enough?
Again, thanks EVERYONE for all the help with this. I feel we're getting closer!
Last edited by lostinperiphery; March 14, 2011 at 10:40 PM.
|