X10 on the primers not seated to the bottom of the pocket. I have used Win, REM, CCI, Fed, and Wolf and not had any issues with any rounds not being lit off.
I use and have used Starline cases almost exclusively in half a dozen or more handguns just about since it became available. I find it to be about the best I have used. If your having issues with it I am guessing it is due to improper die adjustment as pointed out above.
When I load, I seat and crimp at the same time with most all of my handgun loads unless I am doing something special to a particular one. I have crunched plenty of cases over the years setting up with a new bullet or new caliber, but once I get things set I usually have no issues.
Your primers should seat to just below flush of the case heads if they are flush your not seating them enough, give them a bit more and you will see a VAST improvement. Also CCI is one of the better ones you can be using with this particular round.
__________________
LAter,
Mike / TX
|