[TennJed]

I have only been reloading for about 1.5 years now. tonight I ran into a problem and was wondering if I could get some help.

After loading about 50 rounds of 9mm, the resizing/depriming die on my Lee 9mm die quit depriming. As far as I can tell it is still resizing correctly.

It is one of the lee 4 carbide dies. Looking at the instruction booklet, it seems that it might have been pushed up to protect it from breaking and I need to loosen the collet at the top. The pin does not seem to be sticking out as far on the die as my other calibers. I wanted to double check before I did anything.

do I just need to loosen the collet and have the pin fall out? How easy is it to put back and in the right position? What would be the most likely cause of this?