The Firing Line Forums - View Single Post - Ishapore 2A and remanufactured ammo, 7.62 vs .308

moose fat · December 29, 2006, 02:03 PM

Thank you gentlemen,

I am in bush Alaska so everything comes in by air frieght, plus haz-mat fees. It looks like a reloading proposition. I realy do need to reload any way. There is a way!

If you haven't found it already there is a good site;
http://p102.ezboard.com/bparallaxscu...firearmsforums

the Enfield forum.

It sounds like the 7.62/.308 has been discussed since the rounds were first made. From what I have found is that the .308 is/can be 12 000 psi higher than 7.62. The case dimensions at the shoulder and brass thickness-which translates to powder capacity are also different.

Thanks again

December 29, 2006, 02:03 PM	#4
moose fat Senior Member Join Date: June 20, 2006 Location: Alaska, Yukon R. delta Posts: 421	Thank you gentlemen, I am in bush Alaska so everything comes in by air frieght, plus haz-mat fees. It looks like a reloading proposition. I realy do need to reload any way. There is a way! If you haven't found it already there is a good site; http://p102.ezboard.com/bparallaxscu...firearmsforums the Enfield forum. It sounds like the 7.62/.308 has been discussed since the rounds were first made. From what I have found is that the .308 is/can be 12 000 psi higher than 7.62. The case dimensions at the shoulder and brass thickness-which translates to powder capacity are also different. Thanks again