The Firing Line Forums - View Single Post - Full length resizing die question. Picture.

RCP Fab · March 14, 2013, 05:04 PM

I have a lathe at the shop.

The rounds chamber fine, some of these pieces of brass have been reloaded 3 or 4 times now. The brass is a little darker than usual after cleaning and it made the line visible.

That brass in the picture is not trimmed.

March 14, 2013, 05:04 PM	#9
RCP Fab Senior Member Join Date: February 22, 2013 Posts: 113	I have a lathe at the shop. The rounds chamber fine, some of these pieces of brass have been reloaded 3 or 4 times now. The brass is a little darker than usual after cleaning and it made the line visible. That brass in the picture is not trimmed.