The Firing Line Forums - View Single Post

ATTICUS · January 2, 2002, 07:30 PM

It should have been set very close at the factory. If your windage is very far off with the rear site centered, then adjust the front site by simply loosening the hex screw that's holding it, and move it a TINY bit (in the opposite dirction that you need the bullet to go). My new S.A. was so far off that I lost count of the number of clicks needed to center it. Good luck.

January 2, 2002, 07:30 PM	#4
ATTICUS Senior Member Join Date: June 7, 1999 Location: Central Ohio Posts: 2,100	It should have been set very close at the factory. If your windage is very far off with the rear site centered, then adjust the front site by simply loosening the hex screw that's holding it, and move it a TINY bit (in the opposite dirction that you need the bullet to go). My new S.A. was so far off that I lost count of the number of clicks needed to center it. Good luck. __________________ Always do right. This will gratify some people and astonish the rest. Mark Twain