View Single Post
Old February 23, 2006, 05:48 PM   #6
lee n. field
Senior Member
 
Join Date: October 12, 2002
Location: The same state as Mordor.
Posts: 5,567
Quote:
saw an add on ebay, a while back, for some 9x18 mak brass made from 9x19 brass cut down. I didn't know you could do this, as I thought it was a diff. diameter.

Can this really be done?
Yes, it really can be done. I have done it. It is a PITA. Resize fired (and thus oversize) 9x19 brass in a (x18 Mak sizing die and trim to length. Use a shell holder for 9x19, of course.

I wouldn't use someone else's trimmed brass, myself.
lee n. field is offline  
 
Page generated in 0.03358 seconds with 8 queries