View Single Post
Old July 23, 2012, 04:35 PM   #3
Jim Watson
Senior Member
 
Join Date: October 25, 2001
Location: Alabama
Posts: 18,453
I can't say where that Ruger was plated but it is not an expert job and I can't say much good about it or put a very high resale value on it.

The screw holes are dished by hard buffing and the screw slots are boogered from a rough screwdriver. The plastic "pearl" grips don't fit, either.

Then there is the sawn off barrel. If Ruger sold any 4 5/8" .44 Magnums, they didn't make it into the usual references.

Last edited by Jim Watson; July 23, 2012 at 04:42 PM.
Jim Watson is offline  
 
Page generated in 0.02753 seconds with 8 queries