View Single Post
Old October 13, 2011, 07:58 PM   #9
moose fat
Senior Member
 
Join Date: June 20, 2006
Location: Alaska, Yukon R. delta
Posts: 421
This won't answer your question about the op-rod but, you can install an adjustable gas plug. The plug will allow you to use factory loads, without worry of bending the op-rod, or a wider variety of handloaded bullet wts. Brownells has them, Shuster and/or McCann "Adjustable Gas System".

I have the Shuster installed and use my M1 for moose hunting. The Shuster uses a set screw and the McCann uses interchangeable screws for adjustment.

AJ
moose fat is offline  
 
Page generated in 0.02566 seconds with 8 queries