View Single Post
Old December 14, 2012, 04:33 PM   #31
JimDandy
Senior Member
 
Join Date: August 8, 2012
Posts: 2,556
Quote:
The OP can certainly do a better job of finding components at lower cost. First off, buy in bulk not in amounts for a mere thousand rounds.


Factoring the cost of your time in is rather silly. Do you count the cost of the time spent on your other hobbies? If reloading is a chore, one might want to consider not doing it.
Did you miss the part where I said I was "shopping" in one place? Should I also have to add I was trying to use a location that was both well known, had a broad enough selection that anyone could pretty much figure out how to swap in their own components?

I have to admit, I'm a little confused at all the people bitching that even the worst case scenario proving reloading saves money, and a roadmap for others thinking of getting into the hobby isn't good enough, because I didn't squeeze every last penny to make it best case scenario?

I could have included casting. But not everyone can use cast bullets. Not everyone can have powder and primers shipped to their doorstep.
JimDandy is offline  
 
Page generated in 0.02227 seconds with 8 queries