I didn't say drill the receiver. Enlarge the holes in the wood stock. The hammers that strike the firing pins are located under the tang, below the safety. The springs are mounted on rod assemblies that extend behind that point. There are two small holes drilled in the wood to allow clearance for them plus a larger center hole that the stock screw goes through. Remove the butt plate/recoil pad. Use a long, flat tip screwdriver to remove the stock screw. The rear stock will slip off the receiver. No metal removal needed. Just ream out the two small holes in the wood slightly (one drill size at a time) till everything fits. Don't drill deeper, just bigger diameter.
|