View Single Post
Old June 16, 2011, 01:42 AM   #1
deepcore
Senior Member
 
Join Date: July 24, 2010
Posts: 364
Lyman Flash Hole Uniformer Tool question

I bought the Lyman Flash Hole Uniforming tool and have a question about adjusting it.

Instructions say: "...set your cutting length, slide the cone shaped adapter into the entrance of the case mouth. Leave a gap of .010" between the case mouth and cone shaped adapter. Tighten the adapter set screw. Your tool is now adjusted to deburee your cases"

How do I measure the .010" gap between the case mouth and the cone shaped adapter.

Want to deburr and want to make sure I don't enlarge the flash hole by mistake.
deepcore is offline  
 
Page generated in 0.02106 seconds with 8 queries