The Firing Line Forums - View Single Post

dbuffington · December 4, 2010, 04:30 PM

Hi Folks!

I have an older Browning High Power which has been equipped with a rear target sight. If I'm reading the engraving correctly, the sight is stamped "Micro".

To get the gun on target, that rear sight has to be adjusted high ... or at least what appears high to me. So high, in fact, that you can easily press the sight down against the spring and get 2-3 mm of travel.

Does this seem excessive?

Thanks!
Dave

December 4, 2010, 04:30 PM	#1
dbuffington Senior Member Join Date: June 23, 2004 Posts: 157	High Power Rear Sight Height? Hi Folks! I have an older Browning High Power which has been equipped with a rear target sight. If I'm reading the engraving correctly, the sight is stamped "Micro". To get the gun on target, that rear sight has to be adjusted high ... or at least what appears high to me. So high, in fact, that you can easily press the sight down against the spring and get 2-3 mm of travel. Does this seem excessive? Thanks! Dave