View Single Post
Old October 10, 2012, 10:00 PM   #5
drail
Junior member
 
Join Date: February 2, 2008
Posts: 3,150
Be VERY sure when reassembling that the pin in the bolt that limits firing pin forward travel is in place (they fall out on half of these guns). If you fire it without that little stop pin in place the firing pin will damage your chamber. A great many folks have made this mistake. A wood hammer handle makes a good tool to drive the reciever off of the frame. It will loosen up and get easier after a few dozen times.
drail is offline  
 
Page generated in 0.03599 seconds with 8 queries