View Single Post
Old June 10, 2011, 09:00 PM   #8
Kiwi Hunter
Member
 
Join Date: August 13, 2009
Posts: 76
Suggestions... Man up, toss out a pile of her crap and set yourself up a decent bench









(And then quickly come to your senses, bring her stuff back inside and hide all the evidence before she finds out )

In the winter when the garage is a bit too icy I often prep brass, prime, weigh charges etc just on a very small kitchen kitchen table, then dash outside to do any sizing and bullet seating for the few minutes it takes. You really dont need much room for reloading at all.

Your biggest problem there could be mess from depriming, so put some vinyl or something down under the bench. That bench will be a pain till you bolt it down or perhaps fill the bottom full of bricks or something for some ballast.

I am actually fairly suspicious that you will crack the top or pull it off if you ever try to size rifle cases on it...
Kiwi Hunter is offline  
 
Page generated in 0.02334 seconds with 8 queries