Model 1100 operating handle problem
Many thanks g.willikers!
I have actually disaasembled my 1100 as shown in the video, but I wasn't exactly sure about the ball detent and spring situation that keeps the operating handle in place.
I'm supposing the ball has developed a flat spot over the years, or maybe the spring has lost some tension.
I probably should order replacements if they're available.
Thanks again for the swift reply!
It's a pleasure talking with folks with savvy!
I'm a retired prototype machinist so I'm not afraid to go the rest of the way to check everything out.
I just thought maybe there was some simpler solution.
This is a swell site, wish I had joined earlier!
Sharkey453
|