It doesn't get seated. there's no powder, no primer, no dies, no press, not even a usable case yet.
You take a special case that screws onto a shaft at the primer pocket... wire inside the case to manipulate the bullet. Insert whole mess into chamber.. push wire until you feel the rifling... stop, remove mess, probably shake/tap/etc out the bullet.. reinsert onto now locked down wire and measure... Like in the video I linked up there? That explains and demonstrates the whole process? This isn't a loaded round, it's a process to really customize the round to your rifle and chamber- I was just asking if the results I came up with are within the realm of normal/possible for a Remington 700 BDL, or if it was more likely I did it wrong since it was my first time trying to do this.
|