View Single Post
Old August 20, 2012, 06:26 PM   #8
Method
Member
 
Join Date: July 6, 2012
Location: Omaha, NE
Posts: 73
I had the same bulge on the bottom of my shells recently. I'm using a Sizemaster, but the crimping stations should be the same. Here's how I fixed it:

- Check the crimping assembly at the final station.
- Just above the plastic crimper, look for the small nut which secures that particular station in place.
- If that bolt is loose, the assembly won't stay perfectly straight and can create deformities at the bottom of the shell.
Method is offline  
 
Page generated in 0.03253 seconds with 8 queries