View Single Post
Old May 17, 2012, 10:26 AM   #17
serf 'rett
Senior Member
 
Join Date: June 25, 2009
Location: Stuttgart, AR
Posts: 1,569
Quote:
it will loosen up with repeated tapping
Correct!

Quote:
Get a wrench on it.
Did that when I swapped over to the small cylinder, but I snugged up the sucker instead of torqueing it. The surprise, of the bushing backing out, was mostly due to it happening after I had already loaded over 4K rounds prior to the problem occurring.

Got to go get my big wench, er…wrench to tighten the thing
__________________
A lack of planning on your part does not necessarily constitute an emergency on my part.
serf 'rett is offline  
 
Page generated in 0.03084 seconds with 8 queries