View Single Post
Old May 14, 2012, 09:25 PM   #1
smitty77
Junior Member
 
Join Date: December 5, 2008
Location: Idaho
Posts: 10
New Ruger Single Ten problems.

I am wondering if anyone else has had this issue? I recently purchased a new Single Ten for my son, with the cylinder loaded it would drag. It was dragging enough that my son did not have enough strength to index the cylinder. After an inspection you could see brass being left behind on the frame. I contacted Ruger and have since received the "repaired" revolver. They did some filing on the frame and they replaced the pawl. The problem is not fixed and I am not sure what to do now. Besides returning the gun again, what could be a problem that I am missing?
smitty77 is offline  
 
Page generated in 0.03843 seconds with 8 queries