View Single Post
Old January 28, 2013, 05:21 PM   #2
LE-28
Senior Member
 
Join Date: September 24, 2012
Location: North Carolina
Posts: 759
I don't think you will live long enough to polish shells with a rotisary motor.

My home made tumbler is running around 700 rpms. It looks slow even at that speed. It has done a really good job for me since I built it about 25 years ago.

I used a 1725 rpm motor and redused the speed through pulley size to 700. I put a 2"pully on the motor and a 5.25 on the first drive shaft to get this speed. It may be a little fast but it still takes around 2 hours to fully polish a load of 9mm shells.
LE-28 is offline  
 
Page generated in 0.03551 seconds with 8 queries