View Single Post
Old January 29, 2010, 07:36 PM   #3
Lee Lapin
Senior Member
 
Join Date: September 7, 2004
Location: SE NC
Posts: 1,239
Front sights on serious shotguns need to be silver soldered on. That will require a refinish on the barrel when it's done.

Rear sights just need drilling and tapping a couple of holes in the receiver to install. Not too complicated there, but the holes need to line up with the holes in the sight, and be in the right place so the rear sight lines up with the front sight. 8^)

Of all the GR sights out there, so far I still like MMCs best. And I don't like tritium- a white or gold bar down the middle of the front ramp is better IMO. A good 'smith can do that too.

Sorry, I don't know any 'smiths in FL...

fwiw,

lpl
__________________
Mindset - Skillset - Toolset. In that order!

Attitude and skill will get you through times of no gear, better than gear will get you through times of no attitude and no skill.

Last edited by Lee Lapin; January 29, 2010 at 08:02 PM.
Lee Lapin is offline  
 
Page generated in 0.03620 seconds with 8 queries