View Single Post
Old February 19, 2013, 07:31 PM   #17
jepp2
Senior Member
 
Join Date: December 24, 2008
Location: Loveland, CO
Posts: 1,476
Personally I think you made an excellent selection. My own experience is that the Lee carbide sizing die actually sizes further down the case than any of the others (Dillon, RCBS, Lyman) due to the radius being less. On rifle I prefer Redding dies, but I am happier with Lee on revolver and pistol loading than any other die sets.

If you are picking up range brass or shoot with without a fully supported chamber, you may need to run your brass through one of the push through dies. A lot will depend on how hot you load. I check mine in a Lyman cartridge gage just to make sure I will not run into problems at the range. I use the Lee bulge buster since it is carbide and I don't have to use lube.
jepp2 is offline  
 
Page generated in 0.03957 seconds with 8 queries