View Single Post
Old September 15, 2012, 03:57 PM   #8
browninghunter86
Senior Member
 
Join Date: November 14, 2011
Posts: 524
I will play with it. It is not coming out of the side. It seems like the case is not fitting properly onto the opening at the bottom where the powder flows out.

I did at one point have powder leaking out the left side of the measure but like mentioned tightening the screw up some and cleaning the assembly eliminated that issue

Guess I will have to lay paper down to catch it just a PITA to have to deal with
browninghunter86 is offline  
 
Page generated in 0.02731 seconds with 8 queries