Thread: ooops
View Single Post
Old August 4, 2013, 11:16 PM   #1
skizzums
Senior Member
 
Join Date: July 1, 2013
Location: Douglasville, Ga
Posts: 4,615
ooops

so i was giong to order my sizing dies and first i wanted to get my barrels slugged. now, let me say beforehand that i know to only do this with a wooden dowel or something plastic so to not scratch my barrel, but i didn't. so i grabbed a few of my 9mm barrels and i used a flathead screwdriver and just tried to keep it aligned on the back of the bullet, but i didn't. i have about a 3/4 inch long and deep enough to notice scratch in the rifling of the barrel. starts about 1/2 inch into the barrel and stops. i know i'm a dumb@#$, i don't need a lecture, but is there anything i can do? should i even worry about it?

p.s. i switched to a phillips head............
skizzums is offline  
 
Page generated in 0.04513 seconds with 8 queries