|
hey guys, I want to thank everyone for their help. I just got done breaking the rifle down and the issue was quite simple. There is a pin that holds the manual bolt hold lever in place. The pin was partially out of place and stuck at an angle. I used a flat tip screwdriver to realign it and then a brass punch to push it in (without usage of a hammer). Once I reassembled the rifle, I cycled two mags (ten rounds each) through it and not one hiccup. I appreciate the pointers and the fact I didn't have to pay a gunsmith. This means I can go on to purchase a scope for her! Thanks again. -Nate
|