The Firing Line Forums - View Single Post

22-rimfire · March 9, 2013, 12:05 PM

The Remington 541-S (and 541-T) was drilled and taped for a scope at the factory.

The hole spacing is relatively standard, but there can be some variation. There are two groove widths that you will run into as well.

March 9, 2013, 12:05 PM	#2
22-rimfire Senior Member Join Date: February 19, 2005 Location: Tennessee Posts: 5,323	The Remington 541-S (and 541-T) was drilled and taped for a scope at the factory. The hole spacing is relatively standard, but there can be some variation. There are two groove widths that you will run into as well.