The Firing Line Forums - View Single Post

Ammo Junky · June 25, 2007, 04:26 PM

corey006, unfoutunatly, removing the bell is about all that can be done. There will be a gap between the case mouth and bullet. Just adjust you taper crimp until the mouth is the same diamiter as 1/8" down the case. Golden sabers rate well in sd test, but are a B to load becaus of the driving band desgine. :barf: They are darn cheap for a premium bullet, but becaus of the reduced diamiter, I now stick to gold dots.
good luck

June 25, 2007, 04:26 PM	#4
Ammo Junky Senior Member Join Date: March 11, 2006 Location: IL Posts: 537	corey006, unfoutunatly, removing the bell is about all that can be done. There will be a gap between the case mouth and bullet. Just adjust you taper crimp until the mouth is the same diamiter as 1/8" down the case. Golden sabers rate well in sd test, but are a B to load becaus of the driving band desgine. :barf: They are darn cheap for a premium bullet, but becaus of the reduced diamiter, I now stick to gold dots. good luck __________________ Will work for brass. I apologise in advance for spelling errors.