Mike,
I've used a nickel (maybe it was a penny) to tighten mine It didn't hurt anything, but I don't think it's necessary.
You might want to check real good in the area where the barrel mounts down on the frame and make sure there isn't a small burr or piece of trash lifting it at the front. I suppose that would hinder chambering, but it's worth a look.
Gun Parts Corp has six inch barrels if you're interested. About $65. Mine came without a front sight though, and I had to make one. I just copied the pattern on the four inch barrel. 'Haven't shot it with the new barrel and sight yet.
[This message has been edited by sensop (edited March 15, 2000).]
|