View Single Post
Old July 7, 2012, 10:12 PM   #26
Huskerguy
Senior Member
 
Join Date: March 28, 2009
Location: Kansas
Posts: 348
watch this video

This is a pretty good video on smelting and gives some good tips. Edward is correct in that you are likely letting them cool too long before dumping them. I made the same mistake when I got back in to casting. I went ahead and purchased the Lyman molds but the angle iron works just as well and are not that hard to make.

http://www.youtube.com/watch?v=gh4mdoR4Tdk
Huskerguy is offline  
 
Page generated in 0.03207 seconds with 8 queries