View Single Post
Old October 21, 2007, 10:06 PM   #4
Enron Exec
Member
 
Join Date: August 17, 2007
Posts: 27
Its brand new and i didnt clean anything the first time out at the range. After 80 rounds through it, i took it home and stripped it down to the bolt inside the reciever but I left trigger house alone. It was pretty clean, no i still hit most everything wil BreakFree CLP and then blew it out with compressed air. I used a lil oil on the surfaces where i saw wear, a lil dab of Miltec grease on where the bolt ramps up the hammer. I think that is where it has a significant increase in the cycle load like Marshal is mentioning.

How much was the KID radius bolt and trigger? How do you like the trigger?
Enron Exec is offline  
 
Page generated in 0.03267 seconds with 8 queries