|
Thanks!
I did lube each cylinder first. I put some oil on a q-tip and made sure it was heavily lubricated. The cast bullets I used were sized at .452. I put a bullet into the throat of the cylinder, (upside down, so the tip of the bullet would be backward and help get it started) most of the bullet did not fit into the cylinder. I then placed a wooden dowel onto the bullet, and then wacked the dowel with a brass hammer. It was very tight, and took me a while for each bullet. I did use both a micrometer and a dial caliper to double-check. All of the bullets came out .452.
|