View Single Post
Old May 21, 2007, 06:02 PM   #10
badbob
Junior member
 
Join Date: August 17, 2006
Posts: 999
Better idea than above post but same principle, much easier to make.
(1) Find/make disc that fits motor shaft.
(2) Drill a hole in the disc
(3) Make wire actuator from motor to release by bending heavy duty paper clip with a loop on the release end and an "L" shape on the disc end to fit the hole in the disc.
(4) When the disc rotates, the paper clip will pull on the release, opening the safe.

badbob

Last edited by badbob; May 21, 2007 at 06:04 PM. Reason: Edited for clarity
badbob is offline  
 
Page generated in 0.03712 seconds with 8 queries