View Single Post
Old January 22, 2013, 08:52 AM   #15
hounddawg
Senior Member
 
Join Date: March 1, 2009
Posts: 4,232
I would bet he has a air compressor, all he has to do is blow it off before use and periodically when loading. Remove the primer punch and make sure the punch will seat flush in it's holder and there is no debris under the shell plate. In between loading he can dip it in sawdust, well that is a bit extreme but you get the picture.

Once again though I cannot recommend Hornady's toll free line enough, people there will walk him through any and all problems. I have never been on hold more than a minute or two and their people are fantastic
__________________
“How do I get to the next level?” Well, you get to the next level by being the first one on the range and the last one to leave.” – Jerry Miculek
hounddawg is offline  
 
Page generated in 0.03668 seconds with 8 queries