The Firing Line Forums - View Single Post

checkmyswag · October 16, 2011, 04:30 PM

Been using the mag loading tool on a Ruger SR40...

never used one before and i place the tool on the magazine then load up 15 rounds.

Was looking at the follower, it has a scratch/dent in it now from where the mag tool was pressing on it.

I then thought about it, and loaded the first round, then used the mag tool after that.

Feel like I should replace the followers although the gun functions fine.

What do you think and what should I do in the future?

October 16, 2011, 04:30 PM	#1
checkmyswag Senior Member Join Date: January 29, 2011 Location: Texas Posts: 1,328	Mag loading tool damages follower? Been using the mag loading tool on a Ruger SR40... never used one before and i place the tool on the magazine then load up 15 rounds. Was looking at the follower, it has a scratch/dent in it now from where the mag tool was pressing on it. I then thought about it, and loaded the first round, then used the mag tool after that. Feel like I should replace the followers although the gun functions fine. What do you think and what should I do in the future?