|
OK,George! I've stripped the gun down. A little more info. Gun is angle eject, pre-safety. Took out the guts & looked for obvious problems. The 2 cartridge guides are not exact mirror images. Both are same length overall & same thickness at common points along the length. Left guide is straight on top & bottom at .248". Right side has a flat at the back .644" long & same height top to bottom as left guide(.248"), then a small radius down to .196"-.198" from there to the front(~1.553" long). This puts the front shoulder of the right rim slot ~.090 in front of the left rim slot & .062 higher than the left rim slot. There is a pretty substantial burr at the bottom corner of the right rim slot front shoulder. These pieces are obviously cast of tool steel with little to no grinding to final dimension. Did they screw up & put a right side guide in for another caliber?
Thanks, BBBBill
|