Bad lol I mean ... BAD .. lol
So yesterday I finally got to do the pillars, and let's just say .. BAD .. lol
I drilled out the stock, put the pillars in, and I was able to screw in the front action screw, however not the rear one.
Advice ?
Should I drill out the rear pillar a bit to see if I can properly align it all and get the action screw to screw in ?
Or should I drill and tap just tiny bit over sized ?
Also I now may have too much of a lift, gap, at the very front of the stock, so I may have to grind out my damn nice bedding job, get the barrel and receiver to sit tiny bit lower, and redo it ?
|