Thread: Timney trigger
View Single Post
Old December 29, 2012, 01:46 PM   #5
MrBorland
Senior Member
 
Join Date: May 31, 2007
Location: NC
Posts: 2,614
I installed one on a CZ550. Great trigger - clean break, right at 3lbs. A big improvement over the factory trigger. Easy to install, too.

The the fly in the ointment with mine was, in fact, the safety: It utilized the factory safety, but once the round was chambered, and the bolt closed, it couldn't be engaged. It could be engaged before closing the bolt, so something likely needed a little fitting. I ended up selling the rifle to finance another, and never did figure out what needed fitting.
MrBorland is offline  
 
Page generated in 0.03410 seconds with 8 queries