View Single Post
Old May 28, 2010, 01:09 PM   #4
LongRifles, Inc.
Senior Member
 
Join Date: October 21, 2009
Location: Black Hills of S. Dakota
Posts: 195
Here's a trick used by the USMC PWS shop and by the better NRA service rifle builders.

Don't pin it. Drill and tap the holes in the front sight assy for set screws.

Set your rear site to MZ (mechanical zero) and then adjust the front base till it times up and shoots a no wind zero right down the pipe.

Good luck.
__________________
LongRifles, Inc.
"More than a business,
This is a lifestyle."

www.longriflesinc.com
LongRifles, Inc. is offline  
 
Page generated in 0.03430 seconds with 8 queries