Quote:
|
so poorly made it's flexing, twisting, and putting unanticipated stress on the holo-site.
|
Interesting theory. A single clamping point on a 1013 rail, you'd think not... but perhaps a pressure point that applies a load to the sight body, distorting it and in turn, causing the lens to crack? Perhaps amplified by flex in the receiver? All possibilities to support a theory.
Without having the parts in my hands to check the fit and observe the possible causes for failure... the most obvious cause is a flaw in the construction of the sight.
One would assume (oops... assumption is the mother of all ______ ) that the lens is isolated, or otherwise tolerant of shock and distortion loads... to a point.
Cheers,
C