|
go to marlinowners.com. do a search and read the comments.
here is how to fit the trigger
1. Open the action half way.
2. Remove the lever screw.
3. Remove the lever.
4. Remove the bolt.
5. Remove the ejector.
6. Depress the portion behind the trigger that the lever would press when closed, put your thumb on the hammer, pull the trigger and lower the hammer down to the receiver.
7. Remove the stock screw.
8. Remove the stock.
9. Push the hammer spring retainer to the left side and remove the retainer and spring.
10 Remove the hammer screw & pull the hammer out the top thru the tang.
11. Remove the bottom action screw - just next to the magazine tube.
12. Turn the rifle to the other side (left side) - remove the other action screw (lower middle of receiver).
13. Gently pull down on the lower receiver piece (where the trigger spring retainer sits).
14. Once off the rifle, look and find the small retainer pin that holds the trigger in place (really obvious). Pop it out to the left.
15. Push the factory trigger forward - towards the barrel. Pull down and remove. It's two pieces.
16. Push your WWG trigger (it's one piece) back into it's place.
17. Reverse procedure to re-assemble your rifle.
|