View Single Post
Old October 26, 2001, 08:14 AM   #17
VTR996
Senior Member
 
Join Date: September 19, 2001
Location: OKLAHOMA
Posts: 195
I've found ,by mistake??,it seems to help if I start to seat the bullet about 1/3-1/2 way then turn the cartridge 90 degrees or so then fully seat the bullet this seems to help.

I also crimp in seperate steps.I found this by noticeing that the crimp wasn't fully touching the bullet the same all the way around the case mouth so I started to give the cartridge a half a turn and run it up twice.....seem to help.
VTR996 is offline  
 
Page generated in 0.04178 seconds with 7 queries