View Single Post
Old June 6, 2001, 10:27 PM   #2
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,825
Depends on the brand of gun and how they mounted the bead.
On a Remington, I saw off the bead and as much of the brased-on base as I can, then carefully file the remainder down flush with the barrel. Some guns use a screw-in or press-in bead. If you unscrew or remove the bead, this will leave a hole in the barrel. I also cut these off and file.
Dfariswheel is offline  
 
Page generated in 0.04011 seconds with 7 queries