Thread: AR issue
View Single Post
Old October 9, 2013, 06:11 PM   #38
Swampman1
Senior Member
 
Join Date: February 17, 2013
Location: South Louisiana
Posts: 411
Quote:
If you carefully creep your sizing die down,not 1/4 turn at a time,but try 5 minutes on the clock face,you can size your brass to fall between the high and low step on your Wilson gage.
Well, I've just tried that method exactly the way you just said, even at the point where the die bottomed out and still the case head refuses to go flush with top of gauge.
Swampman1 is offline  
 
Page generated in 0.04651 seconds with 7 queries