View Single Post
Old October 3, 2013, 11:41 PM   #16
DarthNul
Senior Member
 
Join Date: December 21, 2010
Location: Minnesota
Posts: 212
I've got the Lee auto-disk and a Hornady LNL measure. They both work just fine with every powder I've used that wasn't "stick" powder. With stick powder, the Lee works better.

Two tricks to get the auto-disk to drop consistently:

1. The first drop you make after filling the hopper should go right back into the hopper because it's usually heavier than anything you'll get going forward. Do the same thing if you re-start your loading process after taking a break. If the measure sits a long time the charge in the disk will compress slightly.

2. If you use a disk, or disk combination that you haven't used before, run half a pound of powder through it before you load with it. That seems to solve any static electricity problems that could lead to inconsistent drops.
__________________
The most feared gun control law proposal: Require buyers to register all gun purchases with their wives
DarthNul is offline  
 
Page generated in 0.04294 seconds with 7 queries